Le Gel Flux Tigers Eye à été conçu pour être simple et efficace.

• Sans odeur
• Sans fumée
• Aucun pétillement
• Se travaille facilement
• Sans dégât
• Facile à nettoyer
• Produit un résultat lisse et brillant

Pourquoi nous l’aimons particulièrement? Contrairement aux autres flux, avec le Tigers Eye nous il n’y a réellement aucun pétillement, et nous n’avons pas besoin de remettre plusieurs fois du flux pour travailler nos soudures. Une superbe découverte!!

Fabriqué aux États-Unis

– During Application Use safety glasses and gloves. Proper and complete preparation of metal surfaces is key to a superior result.
– Remove all oxidization with bronze wool (BRO 02). Clean off all debris.
– Wipe surface with white vinegar (this allows for a more uniform/dark color)
– Wipe down with water and dry
– To apply chemical use cloth or paper towel as applicator tool. Metal contaminates patinas. Form applicator into small thick pad
approximately 2 x 2 inches.
– Pour patina onto pad and wipe metal with long smooth strokes. Slowly wipe thin layer of chemical then let dry. Repeat thin layers of
chemical letting dry between applications.
– Continue to reapply until level of blackness is achieved.
– Let chemical air dry hard for 24 hours.
– Dries to a Matte finish (dull and flat without a shine).
– Optional. Apply Clarity Finishing Compound to achieve a Glossy, shiny finish.

Kwik-Clean flux remover doesn’t need mixing or diluting. Just spray on Kwik-Clean when you’re done soldering, then use paper towel to clean project thoroughly.

To use with patina: Use a paper towel to apply the patina. Mixing the Kwik-Clean with Patina gives added cleaning of the flux and a finer tone on the patina. After Patina is applied, clean again with Kwik-Clean. Polish as you normally would.